Power Electronics SDRIVE DB Series, Getting Started Manual

Page: 14 / 38

POWER ELECTRONICS DB SERIES
TECHNICAL CHARACTERISTICS
13
2. TECHNICAL CHARACTERISTICS
2.1. Technical Specifications
GROUP 1 GROUP 2
REFER.
DBSD4030 DBSD4045 DBSD4075 DBSD4145
SPECIF.
Max. DC Input Voltage 750Vdc 750Vdc 750Vdc 750Vdc
Applicable Drive
11kW 15kW 18,5kW 22kW 30kW 37kW 75kW
Capacity
Power 2,5kW 3,5kW 5kW 10kW
Braking
Minimum
resistor
30 Ω 20 Ω 12 Ω 6 Ω
resistor
Average braking torque 150% 150% 150% 150%
Enable Duty (ED) 10% 10% 5% 5%
Fault output contact, Slave control
signal
Output signal Heat sink overheat
Protection Heat sink overheat Heat sink overheat, overcurrent
Ambient
-10ºC to +40ºC -10ºC to +40ºC
Temp.
Humidity
<90% (non-condensing) <90% (non-condensing)
Altitude <1000m above sea level <1000m above sea level
Cooling
Method
Natural convection Self-cooling
Environ.
Condit.
Environment with no corrosive gas,
combustible gas, oil mist or dust. Environment with no corrosive gas,
combustible gas, oil mist or dust.
Location
Notes:
•
For drive capacities higher than 75kW up to 250kW, se section ‘4.5.4. Combination
of DB Units – Group 2’.
•
For drive capacities lower than 11kW and higher than 250kW, contact with Power
Electronics.