Power Electronics SD 300 Series, Getting Started Manual

Page: 185 / 354

POWER ELECTRONICS SD300
DESCRIPTION OF PROGRAMMING PARAMETERS
183
Screen Description
Default
value
Range Function
Set on
RUN
CM.4
[27]
Communication
frame
structure
D8/PN/S
1
D8/PN/S1
D8/PN/S2
D8/PE/S1
D8/PO/S1
Select the communication frame
structure and defines the data length,
parity confirmation method and the
number of stop bits:
OPT DESCR. FUNCTION
0
D8 /
PN/S1 8-bit data / no parity
check / 1 stop bit
1
D8 /
PN/S2 8-bit data / no parity
check / 2 stop bits
2
D8/
PE/S1 8-bit data / even
parity / 1 stop bit
3
D8/PO/
S1 8-bit data / odd parity
/ 1 stop bit
YES
CM.5
[27]
Response
delay
5ms 0 to 100 ms
The MODBUS-RTU communication
plays the role of the slave device. The
slave will reply after the time period set
in this parameter. This allows the
master
device attending the
communications within a system
where the master cannot manage a
quick slave answer.
YES
CM.6
[28]
Communication
option S/W
version
0.00 -
Show the software version of the
optional communications card, if there
is any connected.
YES
CM.7 [28]
Communication
option ID
1 0 to 255
Identifier of the communications card
connected to the drive.
YES
CM.8 [28]
Card baud
rate
12Mbps - Communications card baud rate. YES
CM.9
[28]
Communication
option LED
status
- -
This parameter function depends on
the communications card.
YES
[28] Will only be displayed when a communications optional card is installed.