Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model Number: PAG-230/2100
13
Assembly
Make sure that the side handle is fastened properly and cannot
loosen unexpectedly.
Mounting the flange
Fig. 5
Fig. 6
Fig. 5 and 6 show how to mount the flange (11) when using thick (4 – 8 mm)
and thin (2,5 – 4 mm) discs.
The following grinding discs can be used with this grinder.
•
For deburring: grooved, fibreglass reinforced type 27. Dimensions Ø 230 mm.
•
For slitting/ cutting: grooved, fibreglass reinforced, type 41 and type 42.
Dimensions Ø 230 mm.
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model Number: PAG-230/2100
08
Safety instructions
Never carry tool by cord or yank it to disconnect it from electrical socket.
Keep cord from heat, oil and sharp edges.
12. Secure work.
Use clamps or a vice to hold work. It’s safer than using your hand and it
frees both hands to operate tool.
13. Do not overreach.
Keep proper footing and balance at all times.
14. Maintain tools with care.
Keep tools sharp and clean for better and safer performance. Follow
instructions for lubricating and changing accessories. Inspect tool cords
periodically and, if damaged, have repaired by authorized service facility.
Inspect extension cords periodically and replace if damaged. Keep
handles dry, clean and free from oil and grease.
15. Disconnect tools.
When not in use, before servicing and when changing accessories such as
blades, bits and cutters.
16. Remove adjusting keys and wrenches.
Form the habit of checking to see that keys and adjusting wrenches are
removed from tool before turning it on.
17. Avoid unintentional starting.
Do not carry plugged-in tools with finger on switch. Be sure switch is off
when plugging in.
18. Outdoor use extension cords.
When tool is used outdoors, use only extension cords intended for use
outdoors and so marked. Always use tool in conjunction with a residual
circuit breaker device.
19. Stay alert.
Watch what you are doing. Use common sense. Do not operate tool
when you are tired.
20. Check damaged parts.
Check the angle grinder for damaged parts before use. Check for
alignment of moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its operation. Any
part that is damaged should be properly repaired or replaced by our
customer service centre unless otherwise indicated elsewhere in this
instructions manual. Have defective switches replaced by our customer
service centre. Do not use tool if the switch does not turn on and off.
21. Warning.
The use of any other accessory or attachment other than recommended
in this operation instructions or the catalogue may present a risk of