![background image](http://html.mh-extra.com/html/power-craft/79127/79127_instruction-manual_1586309029.webp)
29
NO
SE
FI
GB
DE
DK
PL
ET
Use
Note! The OPERATE/BATT TEST button must
be in the OPERATE position to turn the
metal detector on.
Prepare and turn the metal detector on as
described.
Move the search coil from side to side in a
steady motion 2-5 cm above the ground
and listen for any change in the sound and
look for fluctuations on the VU meter.
When a metal object is detected under
the metal detector, narrow the movement
down until you have located the exact spot
that has caused the fluctuation. Then move
the search coil back and forth over the spot,
and determine where the response is most
marked.
Examine the identified spot, and dig
carefully to find the metal object that
caused the fluctuation.
Finding the right place to dig requires
practice.
The search coil and shaft are watertight, so
you can use the metal detector in shallow
water.
Take care not to get water in the control
box.
Cleaning and maintenance
Wipe the metal detector with a well-wrung
damp cloth after use.
If the search coil has been used in water,
it must be thoroughly rinsed in clean tap
water and dried.
Remove the batteries to avoid leakage
if the metal detector will not used for an
extended period.
Summary of Contents for 79127
Page 50: ...50 NO SE FI GB DE DK PL ET ...
Page 51: ...51 NO SE FI GB DE DK PL ET ...