CONFORMITY
Installation and user
guide
Important: Assembly / maintenance of the appliance must be carried out by qualified personnel and in
accordance with applicable laws and regulations.
The manufacturer assumes no responsibility for the use of products that have to comply with particular
environmental and / or installation standards.
Important note
Before connecting the equipment, it is recommended that you read the instruction manual carefully and
keep it for future reference. It is also recommended to perform the electrical connections correctly as
per enclosed drawings, observing the instructions and the Standards.
N.B. Refer to the documentation in all cases where the symbol is on the side
EN 50194
EN 50270
Compliant EN 60079-29-1
Installation EN 60079-29-2
Reports issued by TUV Italia
Channel: Beinat gas solutions
Electric connections also available on
Stand-alone Gas Sensor SG800
V. R4
The SG800 is born from the elegance and prestige that has always distinguished BEINAT S.r.l. and from
the home fitness concept.
The probe is a Catalytic gas detection unit with IP66 protection that, together with one of BEINAT’s industrial
type Control Units or stand-alone, detects the presence of esplosive gas such as Methane, LPG, Hydrogen,
Freon, Chlorine, Idrogen Sulphide, OXYGEN, and other type of gas.
The probe has two danger levels:
1
st
LEVEL, pre-alarm. This was set at see Table on page 2
2
nd
LEVEL, main alarm. This was set at see Table on page 2
For Oxygen ALARM, for <Oxygen deficiency and > Oxygen Excess
The probe is managed by a microprocessor which not only supplies an alarm signal to the control unit connected
to it, but also allows execution of a self-diagnosis and therefore an AUTOMATIC CALIBRATION,
in order to always
have the maximum detection accuracy.
The self-calibration means the probe adapts in harsh and variable temperature environments, avoiding false alarms
due to anomalous events.
The probe has a 0 ÷ 20 % LEL linear output conforming to the 4 ÷ 20mA standard, for which can be connected
with one of BEINAT's industrial control units.
The important innovation of this probe is:
The possibility to substitute the sensor at the end of the operating cycle or fault by the technician without having
to send to BEINAT Srl.
Instrument of testing TS1008
To facilitate the reading of the functional parameters of the probe as well as the
control of annual operating, the BEINAT S.r.l. has built a new portable tester TS1008.
The tester allows to read all the data in the memory of the probes eand by serial
transmission, it prints the ticket that confirms the testing data, certifying your own work.
