![background image](http://html.mh-extra.com/html/power-craft/44000/44000_instruction-manual_1586268016.webp)
16
the items or surface you are going to drill.
Always use the insulated handle to hold the
drill to avoid risk of electric shock from
concealed power cables.
•
Place a piece of scrap wood under the item if
possible. Avoid the drill damaging objects
under or behind the item, e.g. when drilling in
walls.
•
Always maintain a firm grip on both handles
when using the machine.
•
Avoid blocking the ventilation slots with your
hands.
•
The drill must not be in contact with anything
when starting it.
•
Release the on/off button immediately if the
bit gets stuck in the item. Switch drilling
direction and remove the bit.
•
Always use ear protectors when using the
hammer drill function.
•
Drilling certain substances can cause harmful
dust. Always wear a mask.
•
The drill must be totally stopped before
switching between drilling and hammer
drilling, changing direction or drill speed.
•
Never put the drill down if the chuck is still
rotating (e.g. if the lock button is still
depressed). Wait until the chuck has stopped
completely before putting the drill down, and
pull the plug out of the socket if it is not to be
used further.
•
Avoid touching the drill bit after use. It may
be very hot.
Preparation
Turning the support handle
•
The support handle (9) can be rotated around
the drill chuck to an angle to suit - e.g.
vertically under the machine, horizontal out
to either side. Slacken lock handle, set in the
position required and re-tighten.
Changing bits
•
Slacken outer part of chuck (2) to open.
•
Insert the desired drill bit in the chuck and
turn the chuck the opposite way until it has a
firm grip on the bit.
•
Check that the bit is in the centre of the
chuck and is secure.
Drill/hammer drill selection
•
Push toggle switch (3) to the right for
hammer drill and to the left for ordinary
drilling. Select hammer drill for masonry,
stone and cement. Select standard drill for
wood, metals, marble, tiles, lime cement or
man-made materials.
Selecting direction
•
Select direction (left (L) or right (R)) using
the direction selector switch (6). The hammer
drill function can only be used when the
switch is pushed to the right (clockwise
rotation for screwing or drilling).
Setting drill speed
•
Maximum speed can be set by turning the
speed adjustment button (7).
Adjustment of depth guide
•
To drill several holes to the same depth, use
the depth guide (1). Loosen the support
handle, set the guide to the required depth
and tighten the handle again.
USE
•
Fit a suitable bit for the job and adjust the
depth guide again if required.
•
Select the appropriate speed on the speed
adjustment button, select drill or hammer drill
and check that the direction setting is correct.
•
Start the machine by depressing the on/off
button (8) as far as it will go. The further the
button is pressed, the faster the machine will
run (up to max. speed set).
ENGLISH
INSTRUCTION MANUAL
Summary of Contents for 44000
Page 22: ...22 EXPLODED VIEW ...