19
NO
SE
FI
GB
DE
DK
PL
ET
Special safety instructions
The staple gun is designed for securing
light, thin materials such as card, plastic,
film, fabric and leather to wood and other
materials with similar properties to wood.
The staple gun should not be used on
masonry or other hard surfaces. Never use
the staple gun for installing ceilings.
Secure small items in a vice or similar. Never
hold the item in your hand!
NEVER press the safety release in when the
staple gun is not in contact with the item!
If the gun discharges staples or brads into
the air, this can result in serious injury or
material damage.
Check for concealed power cables, pipes
etc. in the items or surface into which you
are going to put staples or brads.
Never use the staple gun for securing power
cables.
Always unplug the staple gun before
inserting staples or brads or removing any
staples or brads that are jammed.
Staples and brads
The staple gun can use staples and brads
with the following dimensions:
A: 0.75 mm
B: 11.3 mm
C: 8-16 mm
A: 1.2 mm
B: 2 mm
C: 16 mm
Loading with brads or staples
Turn the staple gun upside down. Press the
release (4) using your thumb and forefinger
and pull the holder out.
Load the required staples or brads into the
magazine. The tips should point towards
you.
Push the holder in again so that it clicks into
place.
