14
ENGLISH
INSTRUCTION MANUAL
Introduction
To get the most out of your new multisander and
rechargeable screwdriver kit, please read through
these instructions and the attached safety
regulations before use. Please also save the
instructions in case you need to remind yourself of
the tools’ functions at a later date.
Multisander
Technical specifications
Voltage/frequency:
230V ~ 50Hz
Power rating:
130 W
Speed:
8,000 -30,000 rpm
Chuck diameter:
2.3-3.2 mm
Weight:
approx. 500 grams
Multisander parts
1. ON/OFF switch
2. Speed selector
3. Carbon brush holder
4. Shaft lock
5. Collar
6. Chuck
Special safety regulations
•
Never activate the shaft lock when the
multisander is switched on.
•
The multisander must not be subjected to
large loads at slow speeds.
•
If the multisander becomes blocked, it must
be switched off immediately.
•
Do not exceed the maximum permitted
rotation speeds (rpm) for the various
attachments.
•
Due to the risk of fire, you must not use the
multisander on alloys that contain over 80%
magnesium.
Changing the multisander
attachments
1. Disconnect the multisander from the mains.
2. Press and hold the shaft lock.
3. Loosen the chuck using the chuck key.
4. Insert the shaft of the attachment into the
chuck.
5. Tighten the chuck using the chuck key.
6. Connect the multisander to the mains.
Attaching the flexible shaft
