25
ENGLISH
INSTRUCTION MANUAL
Connecting the throttle cable
Carefully open the connector (d) using a suitable
screwdriver. Remove the connector from the cable.
Couple the wires in the two cables and replace the
connector. Squeeze the connector until the top
and bottom click together.
Connecting the leads
Push the contact plugs on the leads between the
motor and gearbox together, paying attention to
their colour codes.
Connecting the auger and gearbox
Push the clamping band (e) on the auger upwards
and pull the cotter pin (f) out of the hole.
Slot the auger shaft over the motor shaft, ensuring
the holes in the shafts line up with one another.
Push the cotter pin through the holes and slide
the clamping band into place.
e
f
Assembling the auger and gearbox
Leads
Connecting the leads
d
d
d
Close in this direction
Throttle cable
(gearbox side)
Throttle cable
(motor side)
Connecting the throttle cable
