3 - Configure the Communica on Se ngs
A - Connect to the Device
B - Factory Reset
I. Connect a CAT5 Ethernet Cable directly
between the Ethernet ports on the
router and G3 to be configured.
II. Ensure the power is connected to the
device and a link is established, indicated
by the LEDs.
III. Type in the IP address in the browser
(default: 192.168.1.50). A field has been
provided on the back s cker in case it has
been changed
IV. From the home page you can navigate
throughout the rest of the site by using
the naviga on bar on the le .
To perform a factory reset:
I. Insert an object, such as the end of a probe, into the hole labelled
"RST"
in the
top le corner of the device
and depress the concealed bu on while applying
power to the device. Keep the bu on depressed un l both the
"SYS"
and
"COM"
LEDs stay green (about 5 seconds).
II. Release the bu on and the device will restart with its default values.
Quick Start Guide
G3
BriteSpot
Temperature Monitoring
Powell Canada Inc,
Suite 201, 55 Gos ck Place
North Vancouver, BC, V7M 3N2
Note that if connec ng via Ethernet to a computer directly, the Internet Protocol Version 4 IP address must be set in the
network se ng on the computer.
The first 3 numbers (separated by periods) of the Internet Protocol Version 4 IP address
should match that of the BSG3 being used, while the last number remains different. For
example, if the BSG3 IP address is the default 192.168.1.50, the Internet Protocol
Version 4 IP address can be set to 192.168.1.3.
To do this, open Network and Sharing Center on the computer. Open the Ethernet
Connec on (or Local Area Connec on) labelled “Uniden fied network”, then
open Proper es. From the List, select Internet Protocol Version 4 and then click
Proper es, where the IP address can be set.
