PowCon SGS 30A, Owner'S Manual

Page: 22 / 32

OM-183 304 Page 16
5-3. Gun Drive Assembly Maintenance
Ref. 149 967-B / Ref. 800 945-A
Retract wire onto spool.
1
Setscrew
2 Current Pick-Up Tab
This tab helps prevent burnback
caused by welding arcs inside the
contact tip. This tab may be re-
moved to provide an insulated drive
roll. (If tab is removed, a smaller di-
ameter contact tip is recom-
mended. See options in Parts List.)
Lightly grease top of tab before rein-
stalling.
3
Drive Roll
Use wire brush to clean drive roll.
Install drive roll with desired groove
down, and turn drive roll so one set-
screw faces flat side of shaft.
4
Bearing
Use wire brush to clean bearing.
Line up drive roll groove with bear-
ing groove and liner opening. Tight-
en setscrews.
Thread welding wire through gun
(see Section 3-3 in the Owner’s
Manual). Close and secure pres-
sure roll assembly. Adjust drive roll
pressure, if necessary (see Section
3-8 in the Owner’s Manual). Rein-
stall top cover.
Tools Needed:
5/16 in
4
3
1
2