20
SERVICE AND ADJUSTMENTS
TRACTOR
FIG. 18
RETAINER
SPRINGS
(BOTH SIDES)
RETAINER
SPRINGS
(BOTH
SIDES)
ELECTRIC
CLUTCH
PULLEY
FRONT
LINK
SUSPENSION
ARMS
RETAINER
SPRING
ANTI-SWAY
BAR
TO REMOVE MOWER (See Fig. 18)
Mower will be easier to remove from the right side of tractor.
•
Place attachment clutch switch in “DISENGAGED”
position.
•
Move attachment lift lever forward to lower mower to its
lowest position.
•
Roll belt off electric clutch pulley.
•
Disconnect anti-sway bar from chassis bracket by
removing retainer spring.
•
Disconnect suspension arms from rear deck brackets
by removing retainer springs.
•
Disconnect front links from deck by removing retainer
springs.
•
Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT:
If an attachment other than the mower deck
is to be mounted on the tractor, remove the front links.
DEFLECTOR SHIELD
TO INSTALL MOWER (See Fig. 18)
•
Raise attachment lift lever to its highest position.
•
Slide mower under tractor with deflector shield to right
side of tractor.
•
Lower lift lever to its lowest position.
•
Connect front links to mower deck and secure with
retainer springs..
•
Connect suspension arms to rear deck brackets and
secure with retainer springs.
•
Connect anti-swaybar to chassis bracket and secure
with retainer spring.
•
Install belt into electric clutch pulley groove.
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
•
Depress brake pedal fully and set parking brake.
•
Place attachment clutch in “DISENGAGED” position.
•
Turn ignition key to “STOP” and remove key.
•
Make sure the blades and all moving parts have completely stopped.
•
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
For Parts Call K&T 606-678-9623 or 606-561-4983
www.mymowerparts.com
