background image

4

 

CAUTION:  Do not operate this lawn 

mower without the discharge guard or an 
entire approved grass catcher in place.  
These guards are for your protection and 
are required by the American National 
Standards Institute and Consumer Prod-
ucts Safety Com mis sion.                                                      

 

CAUTION:  Disconnect spark plug wire 

from spark plug and place wire where it 
cannot come in contact with plug.

HOW TO SET UP YOUR LAWN 
MOW ER 

UNFOLD HANDLE 
IMPORTANT
:  Unfold handle carefully so 
as not to pinch or damage con trol cables. 

2 POSITION / “ADJUSTABLE” HANDLES 
•   Raise handles until lower handle section 

locks into place in operating position.

ASSEMBLY

TO REMOVE MOWER FROM CARTON

•   Remove all loose parts from carton.
•   Remove lawn mower hous ing with care.  Avoid touch ing blade under hous ing.  Always 

wear gloves or other protection when working under or lifting mower.

THINGS TO KNOW BE FORE YOU ASSEMBLE OR OPERATE YOUR LAWN 
MOW ER

Do I have a side or rear discharge lawn 
mower?
Look for the grass discharge opening on 
your mower.  If the opening is on the right 
side of the mower housing, it is a side 
discharge mower.  If the opening is at the 
back of the mower housing, it is a rear dis-
charge mower.  Only rear discharge lawn 
mowers have a grass catcher in clud ed with 
the mower.  Approved grass catchers for 
side discharge mow ers may be purchased 
from your nearest au tho rized dealer.
Do I have a mulching lawn mower?
Look for the grass discharge opening on 
your mower.  Raise the discharge guard 
(rear door on rear discharge mowers).  If 
the opening is closed off by a plate, then 
your lawn mower is mulcher ready.  To 
convert to a discharging mower, see the 
Operation section of this manual.

LEFT

HAND

SIDE

RIGHT

HAND

SIDE

FRONT

What is the right and left side of the 
lawn mower?
When right hand (RH) or left hand (LH) is 
mentioned in this man ual, it means when 
you are in the operating po si tion (stand ing 
be hind the handle).
What kind of engine is on my lawn 
mower?
When learning how to operate your new 
lawn mower, you will need to know what 
kind of engine powers the mower.  A decal 
on the engine will indicate the man u -
fac tur er and type or brand name of the 
engine.

BRIGGS & STRATTON ENGINES

BACK or REAR

(Op er at ing Position)

®

HONDA

ENGINES

TECUMSEH 

EN GINES

17

3 POSITION “EZ”
The handle on your lawn mower has three 
(3) height positions - adjust to height that 
suits you.
•   Remove knob and carriage bolt on one 

side of the lower handle.

•   While holding handle assembly, remove 

knob and car riage bolt from opposite 
side, align hole in handle with desired 
hole in handle bracket and reassemble 
bolt and knob and tighten securely.

•   Align opposite side of handle with same 

positioning hole and secure with bolt and 
knob.

Handle 

adjustment 

bracket

Knob

Bolt

High
Med.
Low

3 POSITION “QUICK” 
The handle on your lawn mower has three 
(3) height positions - adjust to height that 
suits you.
•   Squeeze the bottom ends of lower 

handle towards each other until the pin 
in handle can be inserted into one of the 
three height adjustment holes.

High

Handle 

adjustment 

bracket

Handle pin

Medium

Low

SQUEEZE

REAR DEFLECTOR (IF EQUIPPED)
The rear defl ector, attached between the 
rear wheels of your mower, is provided to 
minimize the pos si bil i ty that objects will 
be thrown out of the rear of the mower 
into the operator mowing position.  If the 
defl ector becomes dam aged, it should be 
replaced.

ENGINE

CARBURETOR
The carburetor has been preset at the fac-
tory and ad just ment should not be neces-
sary.  However, minor ad just ment may be 
required to compensate for differences in 
fuel, temperature, altitude or load.  
•   The air fi lter must be assembled to the 

car bu re tor when running engine.

•   Best carburetor adjustment is obtained 

when fuel tank is 1/4 full.

•   In order for the engine to run, the opera-

tor presence control bar must be held 
in the operating position.  There fore, 
and assistant will be required to hold 
the control bar in the operating position 
when making fi nal adjustment to the 
car bu re tor.

See the ADJUSTMENT section of your 
engine manual for further instructions.

ENGINE SPEED
The engine speed has been factory set.  
Do not attempt to increase engine speed  
as it may result in personal injury.  If you 
believe the engine is running too  fast 
or too slow, take your lawn mower to an 
authorized engine service center for repair 
and adjustment.

THROTTLE CONTROL
If it becomes necessary to adjust or re-
place the throttle control, see the ADJUST-
MENT section of your engine man ual.    

Summary of Contents for PO500N22SH











Reviews: