6
ASSEMBLY
INSTALL MOWER AND DRIVE BELT
(See Figs. 4-12)
See MOWER AND DRIVE BELT ASSEMBLY Supplement
Sheet for additional guidance on this assembly.
Be sure tractor is on level surface and engage park ing
brake.
•
Lower attachment lift lever to it's lowest position.
CAUTION: Lift lever is spring loaded. Have
a tight grip on lift lever, lower it slowly and
engage in lowest position.
•
Turn steering wheel to the left as far as it will go and
position mower on right side of tractor with deflector
shield to the right.
•
Remove plastic tie securing belt, bring belt forward
and check belt for proper routing in all mower pulley
grooves.
02965
02
05
1
A
ASSEMBLE FRONT WHEEL TO
MOWER (See Fig. 3)
•
Using shoulder bolt, washer and locknut from parts
bag, as sem ble front wheel to mower as shown. Tighten
securely.
FIG. 3
FIG. 4
FIG. 5
FIG. 2
A
NOTE: You may now roll or drive your tractor off the skid.
Follow the ap pro pri ate instruction below to remove the
tractor from the skid.
WARNING: Before start ing, read, un der stand and fol low
all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID (See Op-
er a tion section for location and function of
con trols)
•
Raise attachment lift lever to its highest po si tion.
•
Release parking brake by de press ing brake ped al.
•
Place freewheel control in dis en gaged po si tion to dis-
en gage trans mis sion (See “TO TRANS PORT” in the
Op er a tion section of this manual).
•
Roll tractor forward off skid.
TO DRIVE TRAC
TOR OFF SKID (See Op-
er a tion section for location and function of
con trols)
•
Be sure all the above assembly steps have been com-
pleted.
•
Check engine oil level and fill fuel tank with gasoline.
•
Place freewheel control in "trans
mis sion engaged"
position (see "TO TRANSPORT" in Operation section
of this manual).
•
Sit on seat in operating position, depress brake pedal
and set the parking brake.
•
Raise attachment lift lever to its highest position.
•
Remove key from bag and start the engine (see "TO
START" in the Operation section of this manual). After
engine has started, move throttle control to idle (slow)
position.
•
Release parking brake.
•
Slowly depress forward drive pedal and drive tractor
off skid.
•
Apply brake to stop tractor and set park ing brake.
•
Turn ignition key to "STOP" position.
Continue with the in struc tions that follow.
Summary of Contents for 411261
Page 30: ...30 SERVICE NOTES ...
Page 31: ...31 SERVICE NOTES ...
Page 35: ...30 NOTES D ENTRETIEN ...
Page 36: ...29 NOTES D ENTRETIEN ...
