6
Small Radius Tip
Reduced Kickback Symmetrical Guide Bar
Symmetrical Guide Bar
Large Radius Tip
S
Low--Kickback Chain, designed with a con-
toured depth gauge and guard link which
deflect kickback force and allow wood to
gradually ride into the cutter.
Low--- Kickback
Chain
Not a Low--- Kickback Chain
Can Obstruct Material
Contoured Depth Gauge
Elongated Guard Link
Deflects
kickback force
and allows wood
to gradually ride
into cutter
TRANSPORTING AND STORAGE
S
Do not grasp or hold exposed blade.
S
Stop unit before leaving work area.
S
Allow unit and gearbox to cool before storing
or transporting it in a vehicle.
S
Store unit and fuel in area where fuel vapors
cannot reach sparks or open flames from wa-
ter heaters, electric motors or switches, fur-
naces, etc.
S
Store attachment so blade cannot accidental-
ly cause injury.
S
Store attachment indoors, out of reach of chil-
dren.
If situations occur which are not covered in
this manual, use care and good judgment. If
you need assistance, call 1-800-554-6723.
SPECIAL NOTICE:
Exposure to vibrations
through prolonged use of gasoline powered
hand tools could cause blood vessel or nerve
damage in the fingers, hands, and joints of
people prone to circulation disorders or abnor-
mal swellings. Prolonged use in cold weather
has been linked to blood vessel damage in
otherwise healthy people. If symptoms occur
such as numbness, pain, loss of strength,
change in skin color or texture, or loss of feeling
in the fingers, hands, or joints, discontinue the
use of this tool and seek medical attention. An
anti-vibration system does not guarantee the
avoidance of these problems. Users who oper-
ate power tools on a continual and regular basis
must monitor closely their physical condition
and the condition of this unit.
SAVE THESE INSTRUCTIONS
ASSEMBLY
WARNING:
If received assembled,
repeat all steps to ensure your unit is properly
assembled and all fasteners are secure.
Examine parts for damage. Do not use dam-
aged parts.
NOTE:
If you need assistance or find parts
missing or damaged, call 1-800-554-6723.
TOOLS REQUIRED
S
Hex wrench (provided)
INSTALLING PRUNER ATTACH-
MENT
CAUTION:
When removing or installing at-
tachments, place the unit on a flat surface for
stability.
NOTE:
The pruner attachment connects to
the engine end shaft through use of a coupler
system. For extra reach, the extension shaft
(included) can be used.
1. Loosen the couplers on the extension
shaft and on the engine end shaft by turn-
ing the knobs counterclockwise.
Attachment
Coupler
Knob
LOOSEN
TIGHTEN
2. Remove the shaft cap from the pruner at-
tachment (if present).
3. Position locking/release button of attach-
ment into guide recess of coupler on
extension shaft.
4. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
Coupler Primary Hole
Upper
Shaft
Locking/
Release
Button
Attachment
Guide Recess
5. Repeat steps to attach extension shaft to
coupler on engine end shaft.
