- 1 -
000-GB DOSIERVERFAHREN_8537
rEgUALTing SYSTEM
GB
(* additional equipment
Gate
Setting-locks 0 - 7 for different seed sizes - described in Seed Chart
- lever (
26/1
).
If calibration for large amounts of seed causes stalling or seed
breakage, set one lock higher than stated in the Seed Chart.
(For grain, fine seed with reducer and overseeding rape use gate
position
„0“
.
Adjust gates in lock
„1“
- see Maintenance.)
Fine Seed Reducer
Reducers are used for undersowing fine seed (e.g. rape seed) - for
installation see
Fig. 27+28
:
1.
Open gates (lever in lock
„3“
).
2.
Shutter
„open“
.
3.
Mount reducer on sowing roller (
Fig. 27
and
4.
turn towards hopper (
Fig. 28
) until
5.
the limiter of the reducer rests against the shutter.
6.
Move gates to position
„0“
.
7.
Reach into hopper and press the reducer against the sowing
roller.
The reducers are installed correctly when they rest against the shutter
(
28/5
), the gate (
28/6
) and the sowing roller (
28/7
).
Sow setting: Gate lock
„0“
Shutter
„open“
Covers (Additional equipment)
The covers incl. locks are only installed for „Overseeding“ and
„Undersowing with reducer“ (
29/1+2
).
(When mounting the locks, ensure that they audibly lock in. To remove,
(
29/3
) lift slightly and pull off backwards.)
Secure the covers in the correct position with the locks:
Overseeding
- middle groove (
30/1
)
Undersowing with reducer
- back limiter (
31/1
)
26
27
28
29
1
0
