GB
MAINTENANCE AND SERVICE
- 16 -
9700-GB KLINGEN-SCHNELLW (354)
Changing the Cutter Blades
1. Insert lever (H) horizontally between cutter disc and
holder (30)
2. Push movable holder (30) down using lever (H).
3. Remove cutter blade (M)
4. Clean forage remains and dirt away.
- around the bolts (30) and inside the lining (32)
5. Check:
•
blade bolts (31) for damage, wear and fitting
•
holder (30) for damage, change in position and fitting
•
lining (32) for damage.
-
Side surfaces must not show signs of deformation (33)
6. Fit cutter blades and remove lever (H)
7. Check:
•
cutter blades (31) for correct position (visual check)
-
Gap (0 mm). The top surface of the bolt must lie free of play.
-
Side gap (B). Bolts must not touch the lining.
•
that cutter blade (M) can move freely on bolt.
Variation 2
Holder for a quick change of cutter blades
Attention!
For Your Safety
-
Regularly check that cutter blades are tightened firmly!
-
Buckled or damaged cutter blades must not be used further.
-
Cutter blades worn on one side can be turned over and installed again.
-
Blade bolts must be replaced when lower edge is well worn or at a
diameter of 15 mm.
-
Cutter blades on a cutter disc should wear out simultaneously (danger
of imbalance).
Otherwise they are to be replaced with new ones (replace in pairs).
Checking the mowing blade suspension
-
Normal check every 50 hours.
-
Check more often when mowing on rocky terrain.
-
Check immediately after driving over a hard obstacle (e.g. stones
pieces of wood, ect).
Carry out a check
- as described in chapter „Changing the Cutter Blades“
Take note!
Damaged, buckled and worn out parts must not be used
further (danger of accident).
TD 23-97-8
31
30
TD 23-97-7
H
M
30
TD 23-97-9
30
min.
15 mm
0 mm
B
B
33
32
TD 23/97/12
31
Visual check