Petaluma Wall Storage Double Door
Page
1
of
3
•
This hanging system is meant for drywall/stud mounting only.
•
If walls are concrete, brick or plaster, please consult your local hardware store for assistance.
•
For safety, installation by two people is recommended.
Tool Required
(Not Included):
Stud Finder Phillips Screwdriver Pencil
Parts Included
:
Wooden Cabinet (1pc) - A Wall Rail (1pc) -B
Hardware Included
:
Toggle Screw (2pcs) -a Toggle (2pcs) – b Wood Screw (1pc) -c Rubber Pad (4pcs) -d
Pre-Assembly:
•
Remove all parts and hardware from the box and lay out on a clear workspace, along with any plastic protective
packaging. Do not dispose of any contents until assembly is complete to avoid accidentally discarding small parts or
hardware.
•
Use the parts and hardware lists above to identify and separate each of the pieces included.
•
The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
MOUNT WALL RAIL TO THE WALL
1. Position the wall rail (b) on the wall and adjust so that the rail is level .Then, use a felt-tipped pen to mark the wall
through the three pre-drilled holes of the rail to indicate the locations of the drywall toggles.
2. Using a manual screwdriver, drive two toggle (b) into the drywall at the marks on the left and right. To install these
toggles (b) into the wall, simply rotate them at the marked location as if they were a large screw, applying smooth
even force. DO NOT HIT THEM WITH A HAMMER AND DO NOT USE A POWER DRILL TO ROTATE THEM.
These toggles are designed to bore themselves into the wall. Continue rotating until the toggle head advances
flush with the wall surface.
