pottery barn kids BELDEN BED Manual Download

Page: 5 / 5

7. If only one drawer is needed, replace that open drawer front using the drawer Fill-in panel (G), make sure the

bead board aligns properly for both the Front panel (A) and Drawer Fill-in panel (G), then fix 2pcs Mending plate

70x40mm (L) through the pre-drilled holes by using 8pcs Small Phillips head screw 8x17mm (K) and Phillips head

screwdriver (not included).

8.Lay the slat roll (E) in between the Front panel (A) and the Back panel (B) using 28 pc Large Phillips head screw

8x30mm (J), affix the Slat Roll (E) to the bed frame and loosely tighten with the Phillips Head Screwdriver. Tighten

all bolts and screws to make sure all are tight and bed structure is rigid. It is recommended all screws be checked

from time to time for safety as the hardware may loosen over time.

Thank you for your purchase.

stores

catalog

www.potterybarnkids.com

Summary of Contents for BELDEN BED

Page 2: ...N Wooden dowel 8x25mm 2 ASSEMBLY 1 Pull 2 Drawer out from the Bottom frame E as shown 2 Attach the leveler M to the Bottom frame E using 4pcs Small Phillips head screw 8x17mm K tighten with Phillips head screwdriver not included ...

Page 3: ...s align Attach the Bottom frame E to the Front panel A using 3pcs Allen bolt 1 4 x32x15mm I and Allen key H 4 Attach the Left Side panel C and Right Side panel D up to slots on the Front Panel A and Back panel B by inserting the hooked ends into the corresponding slots as shown below Ensure that the connections are secure ...

Page 4: ...anel C and Right Side panel D using 4pcs Allen bolt 1 4 x32x15mm I tighten with Allen key H Then tighten the leveler as shown 6 Put the drawer boxes back to the Bottom frame E by aligning the wooden runners making sure the drawer fits properly ...