OPERATION
Fitting the Blade:
•
The blade rotates in a “down-cut” direction. This means that the front of the blade is moving downward while
the rear of the blade is moving upward.
•
Mount the Blade (DD) so that arrow on blade rotates in this
“down-cut” direction. Blade (DD) can be installed / removed by
using the /" (9 mm) end of the Wrench (LL) provided.
1.
. Using the Wrench (LL) provided (or one of your own)
loosen the Capscrew (BB) by turning it CounterClockwise.
2.
. Remove the outer Flange (CC). Make sure Outer Flange
(CC), Inner Flange (EE), and Arbor (FF) are clean and not
damaged.
•
. Mount Blade (DD) to arbor. Install Outer Flange (CC).
Install and tighten Capscrew (BB) by turning it in a
Clockwise direction (Right Hand Thread). Use Wrench (LL)
to firmly tighten the Capscrew (BB) to arbor shaft.
•
After mounting the Blade (DD), it should align over the top
of the wooden insert in the Conveyor Cart (C). During
operation of this unit, the blade can, and should, pass into
the wooden insert, but NOT into the cast aluminum part of
the Conveyor Cart (C).
•
If this is not true, loosen the setscrews that secure the
Bearings (H) to the Head Platform Assembly (B). Position
the Head Platform Assembly (B) to the left or right until the
Diamond Blade (DD) is aligned over the top of the wooden
insert, then re-tighten the Bearing (H) setscrews.
NOTICE
Note that Blade Shaft Capscrew (BB) has RIGHT HAND
THREADS. Installation of the wrong capscrew could
damage the blade shaft!
•
WARNING!
•
Pothier “Wet” diamond blades MUST be used
with water!
•
If cutting without water use only diamond blades
that are intended to be used dry (without water).
•
DO NOT use Abrasive Blades WITH water!
•
Always use respiratory protection when dry
sawing!
