SAFETY INSTRUCTIONS
WARNING
PROHIBITION
These signs will give advice for your
safety
Before leaving our factory every machine is
thoroughly tested.
Follow our instructions strictly and your machine will give
you long service in normal operating conditions.
The working area must be completely
clear, well lit and all safety hazards
removed.
Any persons not involved in the work,
should leave the area.
WARNING!
Use ONLY Reinforced Abrasive Blades or Diamond
Blades with this machine.
Use ONLY blades marked with a maximum operating
speed greater than the blade shaft speed.
DO NOT use carbide tipped, wood cutting, or circular
saw blades with this machine.
Conventional “Wet” diamond blades MUST be used with
water.
DO NOT use conventional “Wet” diamond blades
without water. Using conventional “wet” diamond blades
without water can result in injury or death of the operator
or persons in the work area!
Before performing any maintenance, ALWAYS locate
the machine on a level surface with the engine / motor
OFF and the start switch in the OFF position, and the
power source disconnected.
WARNING!
Always make sure the saw is connected to a properly
grounded electrical outlet. Failure to comply with this
warning could result in serious bodily injury or death!
WARNING!
Before starting up machine make sure you
completely read these instructions. Be familiar
with operation of the machine before operation!
The operator must
wear protective clothing
appropriate to the work he
is doing.
Any persons not involved in the work should
leave the area.
MANDATORY
INDICATION
INFORMATION
INSTRUCTION
