14
CONNECTION BETWEEN THE DRONE AND THE APP
First:
turn on the drone, enter the mobile phone "settings" interface and enter WiFi setting, find
"Dreamer 1_XXXXXX" network and connect it.
Second:
open the App "Potensic Pro" in mobile phone and enter control interface.
GEOMAGNETIC CALIBRATION
The drone has been calibrated and can work normally in the factory. If the drone's geomagnetism is
disturbed, it may need re-calibration. The steps are as follows:
First:
Enter the Potensic App settings interface, click on the second column, and select the
geomagnetic calibration in the list. The left front and left rear lights start to slowly flash,
indicating that the calibration program is started.
Second:
Rotate the drone 360 degrees horizontally, the right front and right rear lights start to
slowly flash. (Pic 1)
Third:
Rotate the drone 360 degrees vertically, the aircraft 4 LED lights will keep always on. Then
the calibration is finished. (Pic 2)
Fourth:
If the 4 LED lights still keep slowly flashing, indicating that the calibration failed, it is
suggested that you need to change a new take-off place and do the calibration again.
First, insert the battery into the drone and short press the battery switch and then long press the
battery switch again for 7 seconds. At this time, the battery indicator is always on and the drone is
turned on.
Then, press down the middle key of the right stick and the Power Button together for a long time to
enter the binding state (Pic 1). The four footlights will flash, the remote control power lights will flash
slowly.
Last, the remote control will emit a short "di" sound, and power lights are always on, drone’s four
footlights are always on. The drone and the remote control is bounded successfully.
Pic 1