Label Printer
Page 1: ...Label Printer ...
Page 2: ... Install a ribbon on the ribbon supply spindle Mount the ribbon supply spindle on the rear hubs 5 Insert the left side first Please be noted that the bigger hub side with 4 ribs must be installed toward the right side of ribbon mechanism 6 Disengage the printer carriage by pulling the carriage release lever upwards 7 Following the direction of the RIBBON label pull the transparent ribbon leader to...
Page 3: ... label pitch 2 Print out thermal print head check pattern 3 Print the internal settings 4 Enter into dump mode Gap Sensor Calibration This utility is used to calibrate the sensitivity of the gap sensor Users may have to calibrate the gap sensor for two reasons 1 Using a new type of label 2 Initializing the printer Note The ERROR LED may flash if the gap sensor is not calibrated properly Please fol...
