TX-3700 series Technical Manual 18
ALARM CLOCK WAKE UP
To utilize Alarm Clock Wake Up function, the user should enter the CMOS setup by
pressing “Del” key at system boot up, choose “Power Management Setup” and make
the “Resume by Alarm” enabled and set the alarm to required time. Save the
configuration and exit the CMOS setup program. The Preset Power on Control will
then be ready.
CAUTION: Please notice that when EuP function is enabled, the alarm clock
wake up function will be disabled automatically.
MODEM RING UP
To utilize Modem Ring Up function, the user should enter the CMOS setup by pressing
“Del” key at system boot up, choose “Power Management Setup” and make the “Power
On by Ring” enabled and connect the RS232 modem to COM1 port. Save the
configuration and exit the CMOS setup program. The Preset Power on Control will
then be ready.
LAN WAKE UP
For LAN wakeup, the item “PCI Express PME” must be enabled in item “PCI Express
PM Function” of “Power Management Setup” in BIOS setup and an operating caller
system connected through LAN to the system is required. It also requires a qualified
networking technician to check the LAN chip ID of the system for the caller system to
wake up. In this application, there is need for 1 master machine and 1 target machine
connected together through LAN.
To get LAN chip ID (MAC address) of the target machine, please run the target
