Part 4
Find joining points on pole display base
Take PD-2601 out of its box and refer to
Pix. 3
that is a picture of the
pole display base unit (lowest part of the PD) with 2 enlarged portions to the
right and a slightly enlarged side view picture to the left to find 2 bottom
locking lugs
A’
; 2 short cylindrical locating bosses B’ to fit into I/O plate; and
2 plastic screw bosses
C’
on side. Please note that the PD cable comes out of
the bottom end of the base tube yet in the illustration pictures the cable is
eliminated for sake of minimum visual confusion.
Insert bottom locking lugs
Turn the pole display base unit opposite to have the bottom locking
lugs
A’
in
Pix. 3
facing left and now insert the 2 bottom locking lugs
A’
on
base unit into the 2 rectangular installation holes
A
on bottom of HT or PB
chassis from the right corner with the pole display slightly inclined to the left
as in
Pix. 4
. Please note that both bottom locking lugs
A’
should be completely
inserted and come out of the bottom plate of HT or PB system as emphasized
by an arrow in the enlarged portion.
Fit in locating bosses
Please always keep a gentle pressure at the bottom end of pole base
(bottom locking lugs
A’
) to the left (away from the sidewall of system chassis)
when moving the upper part of pole toward sidewall and matching the 2 short
cylindrical locating bosses
B’
into 2 round holes
B
in the I/O plate. Please refer
to
Pix. 5
to see the 2 locating bosses
B’
from inside of HT or PB system.
A’
A’
B’
B’
C’ C’
Pix. 3
A
Pix. 4
A’