16
3.
Lift the power adapter up against the top side of the
compartment.
4.
Place two brackets separately on the top and bottom
sides of the power adapter compartment as shown in
the figure. Then, fasten two brackets with four fixing
screws.
5.
Loosen two fixing screws to remove the bracket for
the middle compartment.
6.
Pass the cable of the power adapter through the
cable exit and then connect it to the port on the I/O
plate of your POS system. (Please refer to
Routing
and Arranging Cables
section to thread the cable.)
7.
Neatly thread the cord along the edge of the middle
compartment (1), and then use the cable tie to hold
the extra cable (2) as shown in the figure.
8.
Secure the middle compartment bracket using two
fixing screws.
9.
Lay the POS terminal on a flat surface with its rear
facing towards you. Then, connect the female end of
power cord to the power adapter and the other end to
the electrical outlet.
Cable exit
Cable tie
(1)
(2)