KB3200 Series User’s Manual
4 - 1
IV. PROGRAMMING THE KEYBOARD
A. HOT KEY PROGRAMMING
The KB3200 series programmable keyboard, when connected with
a standard PC or PS/2 keyboard, supportS the “hot key programming”
method which is most useful in instant modification of a few keys in a
preprogrammed keyboard without entering the more sophisticated
programming utility. Of course, the user may also use this feature to
program through out all programmable keys by 5 pages (LP and L1 to
L4) on KB3200 series at will. The whole process of “hot key
programming” contains 4 steps for each key to be programmed and is
illustrated as following:
1. PREPARATION
To enable “hot key programming” feature of the programmable
keyboard, a standard
PC or PS/2 keyboard must be connected
to the
external KB connector of the programmable keyboard before entering
“hot key programming” mode. The user shall then decide which key of
which page is to be programmed and turn the 6 position control key to
the proper position before entering the “hot key programming” mode.
Please note that the 2 programmable keys in the numerical keypad in
KB3200 series and the answer back codes of the position control key in
both series are not covered by the “hot key programming” feature.
Preparation
Enter “hot key
programming”
mode
Input the
content to be
programmed
Exit “hot key
programming”
mode
