Page 8
The header is printed in text mode and the rest part of this slip is printed in
page mode. If FEED button is pressed at this moment, a font table will be
printed in text mode again. To exit the test printing, please turn the printer off
and on again.
SPECIAL ADJUSTMENTS
Paper Near End Sensor
The near end sensor for
paper roll in the printer is
able to have the printer
work with paper rolls of
several bobbin sizes.
Please refer to the picture
at right for the inside of
the paper roll compartment
that there are a plastic
thumb wheel for bobbin size adjustment and a sensor block in the wall. Turn
the thumb wheel to adjust the proper position of sensor block. For desktop
application, the sensor block should be above the bobbin seating on the 2
support rollers on bottom of paper compartment when paper near end. The
acceptable paper roll bobbin outer diameter is between 18 and 24 mm.
58mm Paper Spacing Plate
The application of 58 mm width paper roll in this printer can be achieved
through adoption of an option spacing plate and an internal DIP switch setting.
Please refer to the last chapter of this manual for the DIP switch setting. Please
refer to the middle picture above for the 58 mm paper spacing plate with its
flange at top edge showing out. Insert the noted corners of the spacing plate
into the 3 dents inside the paper roll compartment as arrowed in the left picture
above with point
A
goes in first. Then the 58 mm paper roll sub compartment
is formed as in the right picture above.
A
B
C
58 mm
Compartment
C
A
B
Sensor Position
Sensor Block
Paper Roll
Shaft Hold
