Page 3 of 3
Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to
www.methven.com
or call
customer service for full details.
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
www.methven.com
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
Periodically the filter washer should be removed from the end of the shower hose and cleaned.
Care and Cleaning:
98-0338
Technical Specifications:
Inlet Connections:
All ½" BSP
* Regional specific regulations apply.
Please refer to your warranty statement at
www.methven.com
ROUND BRASS RAIL
Installation Guide
•
Step 1
Wall lining hole should be cut or finished as per
the dimension shown in the diagram on the right.
Cut off the threaded nipple 10±2mm from the wall
lining and apply thread seal tape to ensure a
good seal.
•
Step 2
Screw the elbow onto the nipple ensuring
that the o-ring is sufficiently compressed to
create a watertight seal.
Ensure that the elbow is oriented vertically
with the outlet oriented downwards.
•
•
Elbow Installation (if supplied):
10±2mm
26mm max
ISSUE B
JUN 2016
Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to
www.methven.com
or call
customer service for full details.
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
www.methven.com
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
Periodically the filter washer should be removed from the end of the shower hose and cleaned.
Care and Cleaning:
98-0338
Technical Specifications:
Inlet Connections:
All ½" BSP
* Regional specific regulations apply.
Please refer to your warranty statement at
www.methven.com
ROUND BRASS RAIL
Installation Guide
•
Step 1
Wall lining hole should be cut or finished as per
the dimension shown in the diagram on the right.
Cut off the threaded nipple 10±2mm from the wall
lining and apply thread seal tape to ensure a
good seal.
•
Step 2
Screw the elbow onto the nipple ensuring
that the o-ring is sufficiently compressed to
create a watertight seal.
Ensure that the elbow is oriented vertically
with the outlet oriented downwards.
•
•
Elbow Installation (if supplied):
10±2mm
26mm max
ISSUE B
JUN 2016
Step 3
Connect hose to outlet elbow and handset.
Ensure swivelling cone is connected to the
handset.
•
•
Filter Washer
Non-Swivelling Cone
Handset
Flat
Washer
Swivelling
Cone
