Transport
It is vital that the drive is stopped before transport.
Disconnect the machine from the mains.
▪ In addition, pull out the plug of the device.
Disengage the universal joint shaft on the tractor.
▪ Before disengaging, turn the manual throttle to minimum.
The splitting blade must be retracted before transporting the machine.
Make sure the shut-off rod is also fully retracted.
The machine may only be transported in the vertical position or leaning backwards. For
horizontal transportation, the ventilation screw must be replaced by a G1/2" screw plug.
Machines with a petrol engine may be tipped for transport, but not turned over as engine oil
can seep into the air filter.
▪ This can render the motor useless.
The machine may be tipped to a maximum angle of 30°.
Moving by hand
Hold the machine by the transport handles, tip it back and move it.
Transporting by three-point linkage on the tractor
▪ Attach the machine to the three-point linkage and use the tractor hydraulics to raise it.
If the tractor's rear lights are obscured, a light must be fitted to the rear of the machine (e.g.
magnetic holder, clip-on light, etc.)
Due to the weight of the machine, the tractor-machine combination can become unstable.
In order to test the overall stability, the following formula can be used to calculate the
minimum weight on the front side I
F,min
with a minimum front axle load of 20% of the empty
weight of the tractor:
I
F
I
R
T
E
T
F
T
R
I
F,min
=
I
R
(
x
(
c + d
))
-
(
)
T
F x b
(
0,2 x
)
+
T
E x b
a + b
T
E
(kg) Empty weight of the tractor
*
T
F
(kg) Front axle load of the empty tractor
*
7
7.1
7.2
Transport
23
Summary of Contents for SpaltAxt 8 Spezial
Page 39: ......
Page 40: ...Your Posch Dealer...
