7
increase till to max speed, will stop by itself.
SECURITY INSTRUCTIONS WHEN USING WITH HOT LIQUIDS
•
Be careful when adding and mixing hot ingredients or removing
the lid from the Blender Jar. Steam might escape unexpectedly.
•
Never use this device to process boiling liquids. Liquids must be
within 50°
,
cannot be loaded more than 700ml
,
its speeds must be in
speed 1-2 and cannot blending more than 4 min.
USING HIGH-PERFORMANCE BLENDER
1.
Prepare your ingredients following the recipe. Particularly
heavy or hard ingredients should first be chopped up before
adding them to the Blender Jar.
2.
Place the device on an even and dry work surface.
3.
Place the Jar on the motor base. Please make sure the jar is
well insert into Safety switch bar. Otherwise, the blender will
not work.
4.
Remove the lid and add your ingredients to the Jar. We
recommend adding solid ingredients first and liquid
ingredients afterwards.
5.
Make sure that you do not exceed the max. filling level.
6.
Place the lid on the Jar and press it down to secure it onto the
Jar. The security contact will not be activated otherwise.
7.
Connect the power plug to the connector.
8.
To start the high-performance Blender, set the speed using
the controller dial. Select the switch control to start the
high-performance Blender. Attention: The high-performance
Blender only works if the controller dial is initially set to “0FF”.
Dial the controller dial back to “0FF” if the Blender does not
start operation.
Tip:
800 g of chopped carrots can be process at maximum speed
with 1,200 ml of water. Turn the control dial to MAX for two
minutes and subsequently turn it back to “0FF”. Wait for one
minute. Do not repeat more often than four times. Afterwards, let
the motor cool down completely.
9.
Set the controller dial to Mode function (M) to select between
the functions “Crushed Ice”, “Smoothie”, and “Soup”. The
button you pressed lights up and the selected programme
starts. Pressing the button again stops the programme and all
buttons will light up again. You can now select a new function.