Infrared IR detector with controller
Serie:
FTPC SIK-IR
INSTALATION MANUAL
3/3
FTPC SOA-IR-manual-EN-R1, 26.03.2020
Sensor installation dimension
ź
As shown i the (Fig.1/Fig.2), drill a 14mm diameter hole for (Fig.1) and 13mm for (Fig.2) on the required place, install the
infrared sensor ont he left and connect the plug to the controller.
ź
As Fig.3 shown, stick the detector on the back of the mirror to ensure it is firmly connect the plug to the controller.
ź
ź
ź
ź
ź
ź
ź
ź
ź
Be sure to read and undestand all instructions before installation. For best results have installed by a qualified technician.
Be sure to connect the light and FTPC-SOA-IR to the power supply first before connecting this product to outlet. Failure to connect
to an outlet in this order may cause damage and will void manufacturer’s warranty.
There are no user serviceable parts in the product. Opening the vase may damage product and will void warranty.
Don’t overload the product. Suitablefor dry locations.
Please make sure that the product is connected correctly according to the wiring diagram. Cutting off the connection with the
power grid during the installation.
If the product is used for purposes other than orginally intended or it’s connected in a wong way, no liability can be taken over for
possible damages.
Please keep the sensor probe clean. It is not allowed to touch the outer surface of the optical lens by hand, or cotton to celan it
regularly to avoid dust affecting its sensitivity and causing misoperation of the controller.
Please make sure the sensor is installed in the correct way, otherwise the detection range will be affected.
The sensor lens should avoid the direct irradiation of sunlight, should not close to the heat source to prevent controller
misoperation.
Installation precautions
POS POWER
MPL Power Elektro Sp. z o.o.
ul. Handlowa 13
41-807 Zabrze, PL
