WUX-7300U/7100U
Copyright © Portwell 2018
WUX-7XXXU series User's Guide
71
Serial ATA
Unlike IDE bus, each Serial ATA channel can only connect to one SATA hard disk at a time;
The installation of Serial ATA is simpler and easier than IDE, because SATA hard disk doesn’t require setting up Master and Slave, which can reduce mistake of
hardware installation.
WUX-7300U/7100U supports one SATA interface (SATA3 6.0Gb/S) on board.
8.2
BIOS Setting
It is assumed that users have correctly adopted modules and connected all the devices cables required before turning on ATX power. DDR4 SO- DIMM Memory,
keyboard, mouse, SATA hard disk, graphic connector, power cable of the device, ATX accessories are good examples that deserve attention. With no assurance
of properly and correctly accommodating these modules and devices, it is very possible to encounter system failures that result in malfunction of any device.
To make sure that you have a successful start with WUX-7300U/7100U, it is recommended, when going with the boot-up sequence, to hit “delete ” or ”F2” key
and enter the BIOS setup menu to tune up a stable BIOS configuration so that you can wake up your system far well.
