System Installation
WEBS-5491 Embedded System User’s Manual
2-1
Chapter 2
System Installation
This chapter provides you with instructions to set up your WEBS-5491 embedded
system. Definitions and locations of all the interfaces are described so that you can
easily configure your system.
2.1 Embedded Board H/W Jumper Setting Introduction
WEBS-5491 Embedded system adopts PEB-99A4 mother board. You may configure
the embedded system by setting jumpers of the mother board to match the needs of
your applications. To select any option, cover the jumper cap (SHORT) or remove
(NC) it from the jumper pins according to the following instructions.
*Note: NC stands for “Not Connect”.
Component side:
