Troubleshooting
WADE-8022 User’s Manual
5-1
Chapter 5
Troubleshooting
This chapter provides a few useful tips to quickly get WADE-8022 running with
success. As basic hardware installation has been addressed in Chapter 2, this chapter
will primarily focus on system integration issues, in terms of BIOS setting, and OS
diagnostics.
5.1
Hardware Quick Installation
ATX Power Setting
Unlike other Mini-ITX board computer, WADE-8022 supports ATX only. Therefore,
there is no other setting that really needs to be set up. You must connect to J1 (12V DC
Jack) or J10 (ATX 4Pin 12V Power Connector) to let WADE-8022 power on.
ATX Power emulation AT Mode
You can adjust the JP5 to 1-2 short to emulation the AT mode.
It can let system auto power on when J1 or J10 has been detected your power source
directly.
JP5: ATX / AT Mode Select
PIN No.
Signal Description
1-2 short
ATX emulation AT mode
1-2 open
ATX mode
Please note that you still need to use 12V adapter or ATX power supply to use!!
Serial ATA Hard Disk Setting for IDE/AHCI/RAID
Unlike IDE bus, each Serial ATA channel can only connect to one SATA hard disk at a
time; there are total four connectors, J33, J34, J35, J36 SATAIII (6Gb/s) ports on-board.
The SATA hard disk doesn’t require setting up Master and Slave, which can reduce
mistake of hardware installation. All you need to operate IDE, AHCI or RAID
(0,1,5,10) application for system, please follow up setting guide in BIOS
programming (Table 5-1); Furthermore, you can consult chapter 4.3
Advanced “SATA Configuration” part of the” SATA Mode Selection”.
