Hardware Configuration
WADE-8013/WADE-8014 User’s Manual
2-1
Chapter 2
Hardware Configuration
This chapter gives the definitions and shows the positions of jumpers, headers and
connectors. All of the configuration jumpers on WADE-8013/WADE-8014 are in the
proper position. The default settings shipped from factory are marked with an
asterisk (
♣
).
2.1 Jumper
Setting
In general, jumpers on the single board computer are used to select options for certain
features. Some of the jumpers are designed to be user-configurable, allowing for
system enhancement. The others are for testing purpose only and should not be
altered. To select any option, cover the jumper cap over (SHORT) or remove (NC) it
from the jumper pins according to the following instructions. Here NC stands for
“Not Connect”.
Figure 2-1 WADE-8013 / WAD-8014 Jumper and Connector Locations
