BIOS Setup Information
Phoenix- AwardBIOS CMOS Setup Utility
Super IO Device
Item Help
Onboard FDC Controller
[Enabled]
Onboard Serial Port 1
[3F8/IRQ4]
Onboard Serial Port 2
[2F8/IRQ3]
UART Mode Select
[Normal]
X RxD, TxD Active
Hi, Lo
X IR Transmission Delay
Enabled
X UR2 Duplex Mode
Half
X Use IR Pins
IR-Rx2Tx2
Onboard Parallel Port
[378/IRQ7]
Parallel Port Mode
[SPP]
X EPP Mode Select
EPP1.7
X ECP Mode Use DMA
3
Menu Level
f
↑↓→←
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Onboard FDC Controller
This item allows enable/disable onboard Floppy disk controller.
The choice: Enabled, Disabled.
Onboard Serial Port 1/Port 2
Select an DDR2 and corresponding interrupt for the first and second serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART Mode Select
This item allows users to select Infrared transmission mode.
Normal
Disable Infrared function
ASKIR
Select ASKIR mode transmission
As Infrared transmission function shares onboard serial port 2, COM2 needs to be
enabled.
RxD, TxD Active
This item is to configure Infrared transmission rate. Four options are available :
Hi, Hi
High rate for receiving / High rate for transmitting
Hi, Lo
High rate for receiving / Low rate for transmitting
Lo, Hi
Low rate for receiving / High rate for transmitting
Lo, Lo
Low rate for receiving / Low rate for transmitting
ROBO-8717VG2A User’s Manual
4-14
