System Installation
ROBO-8713 Series User’s Manual
3-3
Memory Frequency
Dual Channel DDR
Bandwidth
Single Channel DDR
Bandwidth
400MHz 6.4GB/s
3.2GB/s
333MHz 5.4GB/s
2.7GB/s
266MHz 4.2GB/s
2.1GB/s
Note:
To maintain system stability, don’t change any of DRAM parameters in BIOS setup
to upgrade system performance without acquiring technical information.
Memory frequency / CPU FSB synchronization
ROBO-8713 series support different memory frequencies depending on the CPU
front side bus and the type of DDR DIMM.
CPU FSB
Memory Frequency
800MHz 400/333*/266MHz
533MHz 333/266MHz
400MHz 266MHz
* When using 800MHz FSB CPU, DDR DIMMs may run at 320MHz (not 333MHz)
due to chipset limitation.
3.3 CompactFlash
Card
ROBO-8713 series reserves one Type II Compact Flash socket for installing Compact
Flash card up to 1GB.
Installing CF
1) To protect hardware, always hold it by the edges. Holding the center of the card
probably won’t damage it, but holding the card by the edges provides an extra
measure of protection.
2) Slide Compact Flash card into the socket.
3) If Compact Flash card does not slide into the socket easily, do not try to force it.
It will not fit if installed backward. Turn it around and try inserting it again.
WARNING
1) Keep Compact Flash card away from direct sunlight, moisture, and magnetic
fields.
2) The True IDE mode does not support hot insertion and removal because of the
probable disruption of signals on the system bus.
StockCheck.com
