System Installation
WEB-45H3 User
’s Manual
3-39
3.7 Troubleshooting
This section provides a few useful tips to quickly get WADE-8212 running with success. This section
will primarily focus on system integration issues, in terms of BIOS setting, and OS diagnostics.
◼
Hardware Quick Installation
ATX Power Setting
Unlike other Single board computer, WADE-8212 supports ATX only. Therefore, there is no other setting
that needs to be set up. However, there are only two connectors that must be connected—J2 (4 pins ATX
power connector) & J3 (20 pins ATX Power Connector) on the WADE-8212 board.
Serial ATA
Unlike IDE bus, each Serial ATA channel can only connect to one SATA hard disk at a time; The
installation of Serial ATA is simpler and easier than IDE, because SATA hard disk doesn’t require setting up
Master and Slave, which can reduce mistake of hardware installation.
WADE-8212 can support four SATA interface (SATAIII, 6.0Gb/s) on board. It has J5 SATA ports on board.
◼
BIOS Setting
It is assumed that users have correctly adopted modules and connected all the devices cables required
before turning on ATX power. DDR4 SO-DIMM Memory, keyboard, mouse, SATA hard disk, VGA
connector, power cable of the device, ATX accessories are good examples that deserve attention. With no
assurance of properly and correctly accommodating these modules and devices, it is very possible to
encounter system failures that result in malfunction of any device.
To make sure that you have a successful start with WADE-8212, it is recommended, when going with the
boot-up sequence, to hit “delete ” or ” Esc” key and enter the BIOS setup menu to tune up a stable BIOS
configuration so that you can wake up your system far well.
