6
9.)
GPS antenna: female SMA..
10.)
System LED: RED- Power indicator; Green- GPS indicator, Yellow- GSM indicator.
Warning! Power off the system until the Red LED completely turns off before unplug or insert the SIM card.
Otherwise, it may damage your SIM card.
11.)
SIM CARD.
12.)
Siren or Horn output select jumper.
IV.
STATUS INDICATOR
System LED:
RED: Power indicator. When the unit power on, the led will light all the time. When power cut off the unit
works with backup battery, the led will flash until all the report is sent to server.
YELLOW: GSM/GPRS indicator. Yellow LED will flash when the device is connected to the server with valid
GPRS connection. It will stay continuously on when it is in GSM mode. It will stay off if there is no GSM
reception.
Green: GPS indicator. This LED will be ON when the unit received a valid GPS data.
Note that the YELLOW and Green LEDs indication will not be valid until the system goes to the working mode,
normally 30 seconds after power on.
V.
PC SETUP AND SYSTEM INITIATION
PC setup Procedure:
(1.) Connect the 3pin to RS232 cable to the DB9 port.
(2.) Open the PC setup program.
(3.) Select the correct COM port for communication.
(4.) Power on the device or press the reset button for at least 2 second.
(5.) Click “ok” to start the program
Note that, if the connection fails, please check the cable connection is secured correctly. Press the reset button
for a longer time, e.g. another 3 seconds.
A. LOGIN dialog window
Select the correct COM port number, then “reset” the unit by pressing the reset button, and next click “OK”.
Note that: it is necessary to power on and reset the PORTMAN device soon after click the “ok” button.
PC setup program will detect the hardware for 60 seconds. If no hardware is detected, it will exit.
During the opening up screen shown as below, user can press “Esc” key to terminate the program.
B. Version No. Checking
The below interface will last until correct UNIT Version No. is checked. (You should run this program before
turn on power of UNIT)
