10
GENERAL INSTALLATION
Installation
1. Using the available brackets mount the
Remote Interface Control Unit as desired
(see Figure 2.) Shown for recessed into wall.
(Kit B-5555-000)
Figure 2. Control Unit recessed mount.
2. For mounting on to wall (see Figure 3), first
remove side screws to separate back bracket
from Control Unit. Mount back bracket to wall.
Slide Control Unit on to back bracket and
install and tighten side screws again.
(Bracket B-5485)
Figure 3. Control Unit mount directly to wall.
3. Use bracket shown in Figure 4 for under
cabinet mounting. Turn same bracket
upside-down (not shown) for table-top mount.
(Kit B-5555-001)
Figure 4. Control Unit under cabinet mount.
4. Typically mount the Base Unit in a horizontal
orientation (Figure 5). Using same mounting
plate, may also be mounted vertically up,
down, or side.
Do not mount Base Unit
upside-down.
Adding “Z” brackets allows for
mounting Base Unit horizontally, but in an
under cabinet orientation. (Kit B-5555-002,
“Z” bracket)
Figure 5. Porter Digital MDM connected with
interface cable.
Control Unit
