7
3. Install each control receiver (1) on the corresponding numbered backstop or gymnasium divider support structure as shown on
installation print, within 3'-0" of the electric winch that it is to control. Use the cable ties (4) provided to attach enclosure
mounting strap to 3-1/2" O.D. superstructure pipe as shown below. Two (2) #10 screws (not provided) may be used to attach to
wood or other type framing structures if necessary.
TYPICAL 3½” O.D.
SUPERSTRUCTURE ATTACHMENT
12002-100
TRANSMITTER
After receiver is mounted, double-check to ensure that the control box number corresponds to the number marked on the
equipment (1 to 1, 2 to 2, etc.).
4. Plug 4-prong twist-lock plug from electric winch into control receiver box (1). Plug 3-prong twist-lock power cord from the
control receiver box into the power source (115 volt, single phase, 60 cycle), using the 3-prong twist-lock receptacle (2) and 1/2"
deep cover plate (3) provided.
5. With the basketball backstop or gymnasium divider curtain in the down position, test the operation of the unit with the No. 12002-
100 portable transmitter control unit.
CAUTION! – Always keep hands away from the V-belts and pulleys when operating unit.
A. Set selector display (1 thru 99) to position 1 by pressing the next button. The numeric LED will illuminate displaying the
address “01” (see illustration above).
B. Press “RAISE” button - backstop or gym divider curtain marked No. 1 should begin up cycle.
C. Set rotary counting limit switches per winch installation instructions.
D. Repeat steps A thru C for all units.
6. All units must be tested through a complete up/down cycle before leaving the jobsite, to ensure proper operation with the portable
transmitter control unit AND limit switch settings.
7. If the transmitter does not activate one or more of the winch units, double-check the coding switch settings.
8. If the receiver is in the proximity of a metal beam or other obstruction, it may be necessary to relocate the receiver to increase the
operating range.
9. Should intermittent operation develop:
A. Stand closer to the basketball backstop or gym divider curtain receiver unit.
B. Replace the battery in the portable transmitter control unit (standard 9-volt alkaline battery).
10. Place the portable transmitter control unit(s)
and this I
NSTALLATION
& O
PERATION
M
ANUAL
in the possession of an authorized
staff member from the electrical contractor, general contractor, or the school, and demonstrate the operation of the system.
