Porter-Cable PXCM302, Instruction Manual

Page: 9 / 68

9 - ENG
Improper installation of the grounding plug can
result in a risk of electric shock. If repair or
replacement of the cord or plug is necessary, do not connect the grounding
wire to either flat blade terminal. The wire insulation having an outer
surface that is green with or without yellow stripes is the grounding wire.
This product is for use on a nominal 115 volt circuit. A cord with a grounding
plug, as shown here, shall be used.
Make sure that the product is connected to an outlet having the same
configuration as the plug (see Fig. 4 ). No adapter should be used with this
product.
Check with a licensed electrician if the grounding instructions are not completely
understood, or if in doubt as to whether the product is properly grounded. Do
not modify the plug provided; if it will not fit the outlet, have the proper outlet
installed by a licensed electrician.
FOR PERMANENTLY CONNECTED MODELS OR MODELS SHIPPED
WITHOUT POWER CORD: This product must be connected to a grounded
metallic, permanent wiring system, or an equipment grounding terminal or lead
on the product.
Grounded Outlet
Box
Grounded Outlet
Plug
Plug
Grounding Pin
Fig. 4
115V
230V
230 VOLT
15 AMP
115 VOLT
15 AMP
I
DANGER
BREAK-IN OF PUMP
No break in procedure is required by the user. This product is factory tested to
ensure proper operation and performance.
DUTY CYCLE
This air compressor pump is capable of running continuously. However, to
prolong the life of your air compressor, it is recommended that a 50% average
duty cycle be maintained; that is, the air compressor pump should not run more
than 30 minutes in any given hour.
PXCM302_E108930_manual-rev-A_0415_v25.indd 9 4/8/15 4:21 PM