Porter-Cable PCX362010, Instruction Manual

Page: 14 / 32

14 15
a
b
ASSEMBLY (CONTINUED)
FIG. 11
FIG. 10
a
b
FIG. 12
SHAFT
WASHER
NUT
HEIGHT ADJUSTMENT KNOB
INSTALLATION
INSTALLING/CHANGING BLADE
1. Insert shoulder screw (j) into height adjustment
knob (m) as shown in Fig. 11.
2. Tighten shoulder screw with Phillips Screw driver
into Hand Wheel. Height adjustment knob should
rotate freely around shoulder screw when raising
or lowering the blade with the Height Adjustment
Hand Wheel.
Ensure riving knife lock lever is in unlock position. See
Fig. 12.
Remove nut and the outer flanged washer from shaft
assembly. Place blade (C) on the arbor shaft with the
teeth on the blade pointing toward the front of the
saw. The Porter Cable logo on the blade will be facing
toward the left side of the saw. Place flanged washer
on the shaft with the large side of the washer towards
the blade, then secure blade assembly with nut. (Fig.
12)
Tighten nut with blade wrenches (K) from the onboard
storage area on the right side of the saw. Open end
wrench will fit on the arbor shaft between the inner
flange washer and the motor assembly (if neccessary,
turn shaft to align flats on the arbor shaft to the
wrench). Closed end wrench will fit on the nut. See Fig.
12a.
Return wrenches (K) to onboard storage location.
Return riving knife lock lever to locked position. Return
throat plate (F) making sure to lock tab on rear of throat
plate under table top as shown in Fig. 12b.
Insert (2) remaining M5 x 25mm (1 in.) hex socket cap
screws (i) through the fence rail (N) and extension wing
(M) and secure with (2) M5 kep nuts (k) as shown in Fig.
10. Use straightedge to ensure extension wing is level
as shown in Fig. 10a and 10b.
C
K
F
m
j
M
N
k
i