-4-
This nailer produces SPARKS during operation. NEVER use the nailer near flammable
substances, gases or vapors including lacquer, paint, benzine, thinner, gasoline, adhesives,
mastics, glues or any other material that is -- or the vapors, fumes or byproducts of which
are -- flammable, combustible or explosive. Using the nailer in any such environment could
cause an EXPLOSION resulting in personal injury or death to user and bystanders.
MAINTAINING THE TOOL
When working on air tools note the warnings in this manual and use extra care when
evaluating problem tools.
TOOL SPECIFICATIONS
All screws and nuts are metric.
FASTENER SPECIFICATIONS:
TOOL AIR FITTING:
These tools use a free-flow connector plug, 1/4 N.P.T. The inside diameter should be
.200” (5mm) or larger. The fitting must be capable of discharging tool air pressure when
disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 psi (4.8 to 6.9 bar). Select the operating pressure within this range for
best fastener performance.
DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
SEQUENTIAL TRIP
This tool is supplied with a sequential trip trigger installed.
The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. This
makes accurate fastener placement easier, for instance on trim installation, toe nailing and crating
applications. The Sequential Trip allows exact fastener location without the possibility of driving a second
fastener on recoil. The Sequential Trip Tool has a positive safety advantage because it will not accidentally
drive a fastener if the tool is contacted against the work – or anything else – while the operator is holding
the trigger pulled.
Do not use oxygen, combustible gases, or bottled gases as a power
source for this tool as tool may explode, possibly causing injury.
FITTINGS:
Install a male plug on the tool which is free flowing and which will release air pressure from the tool
when disconnected from the supply source.
HOSES:
Air hoses should have a minimum of 150 p.s.i. (10.6 kg/cm
2
) working pressure rating or 150 percent of
the maximum pressure that could be produced in the air system. The supply hose should contain a
fitting that will provide “quick disconnecting” from the male plug on the tool.
MODEL
TOOL ACTUATION
LENGTH
HEIGHT
WIDTH
WEIGHT
BN200SB
Sequential Trip
9.25”
9.5”
2”
2.69 lbs.
FN250SB
Sequential Trip
11.25”
11.50”
3”
4.03 lbs.
MODEL
FASTENER SERIES:
GAUGE
FASTENER RANGE
BN200SB
PBN Series
18
5/8” - 2”
FN250SB
PFN Series
16
1” - 2-1/2”
TOOL SPECIFICATIONS
OPERATION
AIR SUPPLY AND CONNECTIONS
MAINTAINING THE TOOL
FN250SB-BN200SB_9R198001RA_PC_16GA and 18GA FINISH NAILER MANUAL_MAN_JM3_107674RevE_Manua
