15
1. Insert the riving knife between the set plate (4) and
retaining clip (7).
2. Tighten the knob (8).
Fig. L
Power cord (Fig. M)
Wrap the power cord (1) as shown. Do not wrap the
power cord around the dust port (2).
Fig. M
INSTALLING THE BLADE ELEVATION HANDWHEEL
(FIG. N)
1.
Bag " A "
_
Attach the blade elevation handwheel (1)
to the elevation rod (2) at the front of the saw. Make
sure the slots (3) in the hub of the handwheel (1)
engage with the pins (4).
2. Attach and tighten the dome nut (5).
Fig. N
Push stick (Fig. J)
A storage bracket for the push stick (1) is located on the
right side of the stand (2). Store the push stick (3) as
shown.
Fig. J
Anti-kickback pawls (Fig. K)
Storage for the anti-kickback pawls (1) is located on the
left side of the stand.
1. Take the anti-kickback pawl (1) and lift up the locking
lever (2) located on top.
2. Place the anti-kick pawls (1) into slot (3) on the set
plate (4) and push down making sure the assembly
is engaged in the slot (3). Push down on the locking
lever (2).
Blade guard assembly (Fig. K)
Storage for the blade guard assembly is located on the
left side of the stand.
1. Take the blade guard assembly (5) and slide the
locking knob (6) up and press the guard assembly
down so that the entire assembly is located on the
set plate (4). Release the locking knob (6).
Fig. K
Riving knife (Fig. L)
Storage brackets for the riving knife are located on the
left side of the stand.
1
2
3
2
1
1
2
3
4
5
1
4
7
8
5
1
2
3
4
6
