Portable Bar Company FOLD+ROLL BACK BAR, Setup Manual, Page: 8 / 14

PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED WITHIN THIS DOCUMENT IS THE SOLE PROPERTY OF THE PORTABLE BAR COMPANY
ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF THE PORTABLE BAR COMPANY IS PROHIBITED.
STEP 5: Pull spring latches to release the working surface. Hold
the working surface while moving it to avoid damage.
STEP 6: Remove the 4 pins located on side frames,
as shown below.
Figure 13
Figure 14
Figure 15
STEP 7: Swing side frames while slightly lifting them.
Figure 16
STEP 8: Unscrew the far back thumbscrew. While you do so,
hold the support bar, once the thumbscrew is fully
out, the support bar will fall if not supported.
Figure 17
FOLD+ROLL BACK BAR ASSEMBLY SETUP STEPS
8
Note: Replace lock pins after swinging side frames.