EN
EN • 9
POWER LAMP FLASHES
1. Charger is not connected to the battery within
2 minutes.
Connect charger and press the MODE-button to select a
charging program.
2. Vehicle socket has been deactivated (max 30
minutes).
The vehicle's 12V sockets are deactivated if no charge is
applied for 30 minutes to protect the vehicle battery.
• Turn vehicle ignition on and off once before charging if the
ignition has been turned off for more than 30 minutes.
• Switch on the vehicle ignition once after the charger has
been disconnected for more than 30 minutes, e.g. through
a power cut.
3. There must be no warning or information mes-
sages relating to low battery status displayed
in the vehicle.
If there are, the sockets will be deactivated after a maximum
of 30 minutes, despite charging being in progress. The
charger must then be connected via a clamp adapter
( available via Porsche Tequipment) to the vehicle’s charging
points.
4. Li-Ion battery only: Under voltage protection
(UVP) has been activated.
The on-board UVP (under voltage protection) prohibts the
battery from being charged. Please refer to the information
on the chapter BATTERIES WITH "UNDER VOLTAGE
PROTECTION".
CHARGING WITH THE CLAMP ADAPTER
An optional clamp adapter is available via Porsche Tequipment. This
enables you to charge a battery if no 12V socket or cigarette socket can be
used.
1. Connect the red and black clamp in accordance with the vehicle manual.
2. Connect the charger to the wall socket.
3. Charge until
Li-Ion
or
Li-Ion
is lit.
4. Disconnect the charger from the wall socket before disconnecting the
battery.
5. Disconnect the black clamp before the red clamp.
BATTERIES WITH "UNDER VOLTAGE PROTECTION"
Some Lithium-ion batteries have an on-board UVP (under voltage
protection) that disconnects a discharged battery. This prohibits the charger
from detecting the battery. To bypass this, the charger needs to deactivate
the UVP.
1. Disconnect the negative terminal of the battery
2. Connect the red and black clamp in accordance with the picture below
3. Connect the charger to the wall socket
4. Select Li-Ion charging program and press the MODE-button for 10
seconds until one of the indication lamps is lit (procedure may be
repeated).
WARNING
DURING THIS PROCESS, THE CHARGER IS NOT SPARK FREE
5. Follow steps 3 to 5 as above ("Charging with the clamp adapter") and
reconnect the negative terminal of the battery.
20020455C Porsche 60W Charge-o-Mat PRO, Manual 1 EU, Print file_002.indd 9
2017-07-06 09:56:05
Summary of Contents for Charge-o-mat Pro
Page 1: ...Charge o mat Pro Bedienungsanleitung User Manual ...
Page 122: ...20020455C ...
