Porsche Cayenne 2005, Owner'S Manual

Page: 163 / 369

WWW.MANUALS.WS
WWW.MANUALS.WS
Controls, Safety, Instruments
163
Allocating garage door opener signals to
the keys
f
Please follow the operating instructions for the
original hand-held transmitter.
Before programming the keypad the first
time with garage door opener signals
This process deletes the standard codes set at
the factory. Do not repeat the process if you
program further buttons.
f Keep the two outer buttons of keypad A
depressed for approx. 20 seconds until
light-emitting diode B begins to flash.
Garage door opener with fixed code system
1. Point the original transmitter at the position
marked.
2. Press the button of the original hand-held
transmitter and at the same time the button to
be allocated on keypad A .
3. Keep both buttons depressed until light-
emitting diode B starts to flash (first slowly and
then quickly).
Only release both buttons when light-emitting
diode B flashes quickly.
The rapidly flashing light-emitting diode B
confirms that the new frequency signal was
programed successfully.
4. Repeat steps 1 to 3 to allocate signals for the
garage door opener to other buttons.
Garage door opener with changeable code
system
1. Allocate the required button as is done for
systems with fixed codes (points 1 to 4).
2. To synchronise the system:
Press the programming button on the receiver
for the garage door actuator.
Afterwards, you usually have approx.
30 seconds to initiate step 3.
3. Press allocated button in keypad
A
twice
(in some devices you must press the allocated
button a third time to complete the setting).
4. Repeat the programming steps to allocate
signals for the garage door opener to other
buttons.
Note
f Please consult your authorized Porsche dealer
if you have not been able to successfully allo-
cate signals for the garage door opener to the
keys even though you have carefully followed
the instructions in this chapter and the operat-
ing instructions for the original hand-held trans-
mitter.
f f f