CAUTION:
Do not advance or retract the cable using the switch trigger
unless the cable is in drain pipe.
OPERATION (CONT.)
The drain auger should be cleaned after each us to prevent contamination and residue build up.
To clean the cable:
● Remove the battery pack from the tool.
● Using a clean cloth and warm soapy water, pull the cable out from the tool, cleaning it as it advances, continue to do until the cable has
been fully advance and completely cleaned.
● Using a clean, dry cloth, pull the cable back into the tool, drying it as it retracts, continue to do until the cable has been fully retracted.
Cleaning the drain auger
MAINTENANCE
WARNING!
When servicing, use only identical replacement parts, use of any
other parts could create a hazard or cause product damage.
CAUTION:
Always be sure that the battery pack is removed from tool when
replacing the cable.
WARNING!
TDo not start the tool to retract the cable, because the exposed
cable can lead to unpredictable personal injury, tool damage, damage to
indoor objects, fire, electric shock and other dangerous situations.
Avoid using solvents when cleaning plastic parts. Most parts are susceptible to damage from various types of commercial solvents and
may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
If the cable can not be replaced normally, please contact Populo customer service at [email protected]
Populo Tools will not be held responsible for any damage or injury caused by mishandling the tool or any repair made by an unauthorized
person.
1. Complete the advance the cable from the drum.
2. Unscrew 4 installation screws for the cable drum with a screwdriver.
3. Loose the fixing screws for the cable with a screwdriver.
4. Pull the cable out from the head of the front handle.
5. Insert new cable from the head of the front handle and tighten the
fixing screw from the cable. (Leave cable 1’’ long free from its end)
6. Reinstall the drum by tighten 4 screws with a screwdriver.
7. Retract the cable back to drum manually.
●
Before inspection and maintenance, please switch off the tool power and take off the battery pack!
●
After each use, please clean the cable carefully, if it is not to be used for a long time, please apply butter on the surface of the
cable to prevent rust.
General maintenance
How to replace the cable
Storage and maintenance of the machine
